Sibir A 30-80 K Instrucciones De Manejo página 30

GB
- Turn thermostat knob (A) clockwise to position 6/MAX. Only after
approximately 1 hour will the unit become noticably cool (frost on
evaporator).
- The temperature can be regulated using the thermostat knob: '0'=off, 1-6
increasing degrees of coolness.
- After sufficient cooling (approximately 5 hours), the thermostat position can
be set to a lower temperature, between 2-5. The thermostat will now
automatically regulate the set temperature.
To turn off (Fig. 1)
- 3-way-switch (D) should be in position '0'.
- Turn thermostat knob (A) anticlockwise to position '0' (a slight resistance will
be felt just before this position).
- Pull out mains plug.
7. D/C operation
Do not use any additional form of energy (mains/gas). A safety fuse must be
installed in the electricity supply between battery and refrigerator in a duct.
12 V: maximum 15 amps; 24 V: maximum 7.5 amps.
Cable cross section
2
2.5 mm
2
4.0 mm
2
6.0 mm
It is not necessary to consider the polarity when connecting the unit. Check that
the battery voltage and line voltage data correspond to the type-plate on the
back of the unit.
If no batteries are used independently of the vehicle, the mobile cooler should
not be operational when the vehicle is in motion, since the battery can discharge
to the extent that the vehicle engine cannot restart when the vehicle is at a
standstill.
During transport, the door safety button (G) must remain depressed, so that the
door is kept in a closed and safe position.
Recommendation: before journey, pre-cool the unit using A/C operation.
To turn on
Plug the car plug must be mounted according to your car on the connecting
cable into the plug connector/cigarette lighter.
When using battery operation, the cooling performance is not thermostatically
regulated, i.e. knob (A) is ineffective.
30
max. cable lengths
12 V
until 2.5 m
until 4.0 m
until 6.0 m
24 V
5 m
8 m
12 m