Craftsman ZT 7000 Manual Del Operador página 8

CONNECTING TUBES
Connecting Upper & Middle Tube
1. Attach upper tube (B, Figure 7) to middle tube (A)
using clevis pins (E) as shown. Secure with washers
(D) and hair pins (C).
2. Reach through upper tube (B) to insert clevis pins(E).
Note: Pivoting the tubes on the clevis pins may give bet-
ter access for connecting washers and pins.
Figure 7. Assemble Bagger Tubes
A. Middle Tube
B. Upper Tube
C. Hair Pins
D. Washers
E. Clevis Pins
Lower Tube Installation
1. Lift discharge deflector up (D, Figure 8).
2. Insert lower chute rod (A) into mounting plate (B).
3. Pull rubber strap (C) and secure by placing hole clos-
est to knob in strap completely over Iocknut (E).
I I
Figure 8. Install Lower Tube
A. Lower Chute Rod
B. Mounting Plate
C. Rubber Strap
D. Discharge Deflector
E. Locknut