Troubleshooting Guide - Panasonic RC-DC1 Instrucciones De Funcionamiento

Note:
• Insert with poles aligned.
• Do not touch the terminals (+ and –) with metal objects.
• Do not recharge, disassemble, remodel, heat or throw into
fi re.
• Keep out of reach of children.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed
to direct sunlight for a long period of time with doors and
windows closed.
• Remove the battery if the clock radio is not going to be used
for a long period of time. Store in a cool, dark place.
If any electrolyte should come into contact with your hands or
clothes, wash it off thoroughly with water.
If any electrolyte should come into contact with your eyes, never
rub the eyes.
Rinse eyes thoroughly with water, and then consult a doctor.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
Warning
Keep the Button-Type battery out of reach of children to
prevent swallowing.
Warning
Risk of fi re, explosion and burns. Do not disassemble, heat
above 60°C (140°F) or incinerate.
For USA-California only
This product contains a CR Coin Cell Lithium Battery which
contains Perchlorate Material - special handling may apply.
12 12
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
12

Troubleshooting guide

Before requesting service, make the following checks. If you
are in doubt about some of the check points, or if the solutions
indicated do not solve the problem, consult your dealer for
instructions.
■ Clock
Clock cannot be synchronized to iPod or iPhone's time.
• Make sure the iPod or iPhone is securely connected and
turned on (Z page 8).
• Update your iPod or iPhone with the latest software.
Daylight saving time does not work.
• Make sure the clock has been set correctly.
• Press and hold [SLEEP] in clock mode to activate daylight
saving time (Z page 7).
■ Alarm
The iPod, radio or buzzer alarm does not sound at the
preset time.
• Check that "ALARM 1" or "ALARM 2" has been correctly
activated (Z page 10).
The iPod or radio alarm is activated but there is no sound at
the preset time.
• Check the alarm's volume setting (Z page 10).