Greenlee HID6506 Operación Manual página 4

IMPORTANT SAFETY INFORMATION
• When using the tool in hammer drill mode, use
accessories that are approved for impact use
only. Accessories that are not approved for impact
applications can break when used in the hammer
drill mode.
• Inspect accessories before use. Discard accesso-
ries that have cracks, chips or gauges.
Failure to observe these warnings could result in
severe injury or death.
Some dust created by power sanding, sawing, grind-
ing, drilling, and other construction activities contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement and other
masonry products
• Arsenic and chromium from chemically-treated
lumber.
To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
• Remove the chuck key from the chuck before drill-
ing. Operation with the key in the chuck can result
in severe injury.
• Keep all parts of the body away from rotating parts
when the tool is in operation. Contact with moving
parts can result in severe injury.
• Do not change accessories, inspect or clean tool
when it is connected to a power source. Accidental
start-up can result in serious injury.
• Maintain a firm grip on tool, using both hands at all
times. Serious injury can result if an operator does
not control the tool.
• Do not lock trigger in the power-ON position.
Operator cannot stop tool when trigger is locked.
Failure to observe these warnings could result in
severe injury or death.
Greenlee / A Textron Company
Hydraulic Rotary Impact Drill
Tool and accessory may be hot
during and after operation.
Contact with hot surfaces could
result in serious injury.
Do not exceed the following hydraulic power source
maximums:
• Hydraulic flow: 45.4 l/min (12 gpm)
• Pressure relief setting: 138 bar (2000 psi)
• Back pressure: 13.8 bar (200 psi)
Failure to observe this warning could result in severe
injury or death.
Do not disconnect tool, hoses, or fittings while
the tool is running or if the hydraulic fluid is
hot. Hot hydraulic fluid can cause serious burns.
Do not reverse hydraulic flow. Operation with hydrau-
lic flow reversed can cause tool malfunction. Connect
the supply (pressure) hose and return (tank) hose to
the proper tool ports.
Failure to observe this warning could result in severe
injury or death.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070