Installing And Removing Drill Bits - Greenlee HID6506 Operación Manual

Installing and Removing Drill Bits

Greenlee Utility recommends using Greenlee impact-
style bits. See Accessories in this manual.
• When using the tool in hammer drill mode, use
accessories that are approved for impact use
only. Accessories that are not approved for impact
applications can break when used in the hammer
drill mode.
• Inspect accessories before use. Discard accesso-
ries that have cracks, chips or gauges.
Failure to observe these warnings could result in
severe injury or death.
Some bits may whip or bend under sideload.
• Do not use bits with a long spiral and center
support.
• When using an impact bit, run the power source
at the minimum flow. Refer to the "Specifications"
section.
Failure to observe this warning could result in severe
injury or death.
Center Support
Greenlee / A Textron Company
x
Long Spiral
Hydraulic Rotary Impact Drill
SDS Plus Type Chuck
1. Inspect the chuck. Remove any dirt or other
contamination.
2. Select an SDS Plus type of bit. Align the long slots
in the shank of the bit with the index mark in the
dust cover on the end of the collar. Insert the bit into
the chuck.
3. Check to make sure the collar is securely holding
the bit.
4. To remove the drill bit, twist the collar so that it
releases the bit.
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070