Publicidad
Idiomas disponibles
Idiomas disponibles
Operating your French Door
Refrigerator
USING THE CONTROL PANEL
1
2
3
( 1 )
The Freezer button serves two purposes:
Freezer/
- To set the Freezer to your desired
Power
temperature.
Freeze
- To turn the Power Freeze function on
(3sec)
and off.
1) To set the Freezer temperature,
touch the Freezer button. You can set the
temperature between 5 °F (-15 °C) and
-8 °F (-23 °C).
2) Power Freeze function
Touch and hold this button for 3 seconds
to decrease the time needed to freeze
products in the Freezer.
It can be helpful if you need to quickly
freeze easily spoiled items or if the
temperature in the freezer has warmed
dramatically (For example, if the door was
left open).
When you use this function, the energy
consumption of the refrigerator will
increase. Remember to turn it off when
you don't need it and return the freezer
to your original temperature setting. If you
need to freeze a large amount of food,
activate the Power Freeze function at least
24 hours before you put the food into the
freezer.
RF30KMED_DA68-02894B-02_EN.indd 17
4
5
10
8
6
7
9
( 2 )
The Alarm button serves two purposes:
- To turn the door open alarm on and off
Alarm/
- To reset the water filter life indicator.
Filter
Reset
1) Door Alarm Function
(3sec)
If the door alarm is set to On, an alarm
beeps if any refrigerator door is left open
for more than three minutes. The beeping
stops when you close the door. The door
alarm function is pre-set to On in the
factory. You can turn it off by pressing
and then releasing the Alarm button. You
can turn it back on in the same fashion.
The icon lights up when the function is on.
When the Door Alarm function is on and
the alarm sound is triggered, the Door
Alarm Icon will blink while the alarm
sounds.
2) Water Filter Life Indicator Function
After you replace the water filter, touch
and hold this button for 3 seconds to
reset the water filter life indicator. When
you reset the water filter life indicator,
the Filter icon on the panel turns Off. The
Filter icon will turn red to let you know it
is time to change the water filter after six
months (about 300 gallons). Some areas
have large amounts of lime in their water,
which causes the water filter to clog more
quickly. If this is the case in your area,
you will have to change the filter more
frequently than every six months.
( 3 )
Touching this button turns Energy Saver
Energy
mode on and off. When you turn Energy
Saver
Saver on, the Energy Saver icon lights.
Turn Energy Saver off and the icon goes
off. The Energy Saver function's factory
setting is "ON". If condensation or water
drops appear on the doors, turn the
Energy Saver mode off.
English 17
2017-05-23
5:14:44
Publicidad
