Types Of Work; Care And Maintenance - Hilti TE 40 Manual Del Usuario

5.1.5 Fitting / removing the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
◁ Use only genuine Hilti grease. Use of the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
3. After fitting the accessory tool, grip it and pull it firmly in order to check that it is securely engaged.
◁ The product is ready for use.
4. Pull the chuck ring back as far as it will go and remove the accessory tool.
5.1.6 Positioning the chisel
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
▶ Set the function selector switch to this symbol:
◁ The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.

5.2 Types of work

WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if
damaged while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged.
Check extension cords at regular intervals and replace them if found to be damaged.
5.2.1 Function selector switch
▶ Set the function selector switch to the desired working position.
◁ Do not operate the function selector switch while the motor is running. Risk of damage!
5.2.2 Drilling without hammering
▶ Set the function selector switch to this symbol:
5.2.3 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
5.2.4 Chiseling 7
▶ Set the function selector switch to this symbol:

6 Care and maintenance

WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
16 English
Printed: 17.03.2017 | Doc-Nr: PUB / 5070952 / 000 / 02
6
7
.
7
7
.
.
.
7