[]
REMOTE CONTROL
UNIT
•
The DVD-2800
can be controlled
from a distance
using the included
remote control
unit (RC-546).
_._ Remove
the remote
control
unit's rear cover.
_2_Place two
"AAA"
(R03) batteries
in the battery
compartment
in the direction
indicated
by the marks.
_C]ose
the rear cover.
Cautions
On Batteries
• Use "AAA"
(RO3) batteries
in this remote
control
unit.
• Replace the batteries
with
new ones approximately
once
a yeah though
this depends
on the frequency
with which
the remote
control unit is used.
• If the remote
control
unit does not operate
from close to
the main unit, replace the batteries
with new ones, even
if less than a year has passed.
• The included
battery
is only for verifying
operation.
Replace it with a new battery
as soon as possible.
• When
inserting
the batteries,
be careful
to do so in the
proper
direction,
following
the (_ and O marks
in the
remote
control unit's battery
compartment.
• To prevent
damage
or battery
fluid leakage:
• Do not use a new battery
with an old one.
• Do not use two different
types of batteries.
• Do not short-circuit,
disassemble,
heat or dispose
of
batteries
in flames.
• Remove
the
batteries
when
not planning
to use
the
remote
control unit for a long period
of time.
• If the battelies
should
leak, carefully
wipe
off the fluid
from the inside
of the battery
compartment,
then insert
new batteries.
Approx 7 meters
_.
• When
operating
the remote
control
unit, point it at the
remote
control
sensor as shown
on the diagram.
• The remote
control
unit can be used
from
a direct
distance
of approximately
7 meters.
This distance
will
be shorter,
however,
if there are obstacles
in the way
or if the remote
control
unit is not pointed
directly
at
the remote control
sensor.
• The remote
control unit can be operated
at a horizontal
angle of up to 30 ° with
respect
to the remote
control
sensor.
NOTES:
• It may be difficult
to operate
the remote
control unit if the remote
control
sensor is exposed
to direct sunlight
or strong artificial
light.
• Do not press buttons
on the main unit and on the remote control
unit at the same time. Doing so will result
in malfunction.
15