Troubleshooting - OHAUS SF40A Manual De Instrucciones

Find Quality Products Online at:
SF40A Printer

7 Troubleshooting

Problem / Message
Printout unreadable
Pilot lamp does not light
Pilot lamp flashes
Timeout
-------------- ---------------
Over Load
------------ -------------
Under Load
------------ -----------
Transmission Error
-- --
GlobalTestSupply
www.
Possible cause Correction
 Ribbon worn or  Change ribbon cartridge
entangled. or tense the ribbon
properly.
 Service life of
printing unit at an  Please contact OHAUS
end. service.
 No power.  Switch printer on.
 Power supply fault.  Please contact OHAUS
service.
 No connection  Make sure that the
printer device. printer and the
instrument is connected.
 Printer did not find  Switch the printer off/on.
the settings of the
 Alternatively change the
connected
settings of the printer or
instrument.
the connected
instrument. (see chapter
2.4)
 Data transfer has  Move balance to more
not completed in stable location.
the last 45 s.
 Check the balance.
 Balance in  Check the sample
overload range. weight.
 Zeroing out of the  Change the zero range
zero range. of the balance.
 Change the setting of
the printer from zero to
tare.
 Balance in  Check the balance.
underload range.
Weighing pan is
not in position.
 Instrument does  Check interface
not understand parameter settings on
printer instruction. printer and instrument.
EN-15
.com
sales@GlobalTestSupply.com