Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3
Set the appropriate width of the gate by overlapping the two
frames to the extent necessary to allow room for the spindles
on either side of the gate. The minimum allowable overlap is
two bars. The maximum allowable overlap is seven bars.
Note: The spindles are adjustable to accommodate the gap
between the gate frame and the opening.
Step 4
Secure the gate frames together by re-installing
the upper and lower assembly fittings on the
gate frame by reinserting the screws.
Step 5
Note: *Do not mount hardware into sheetrock or plaster.
Hardware is included for use in solid materials only such as
wood or metal.*
Hold template (A) against the surface to which the gate is to
be fitted (hinge side). Ensure the template is vertical,
completely outstretched and that the end marked "
the floor. Mark the screw hole positions.
Step 6
Disconnect both the upper and lower hinges by sliding the
top hinge pin/hinge apart. Secure the lower and upper
hinges with the mounting screws with the post pointing
upwards as shown.
Note: Do not secure the top hinge with pin at this time.
Step 7
Hold template (B) against the surface to which the gate is to
be fitted (latch side). Follow the directions in step 5.
" is on
Page 3
Hinge
Handle
latch side
Publicidad
