Publicidad
Idiomas disponibles
Idiomas disponibles
When using the gate at the top of the stairs, never allow the gate to swing over the stairs.
Note: Both the upper & lower latch housings have a raised edge. The raised edge should be installed on the side
to which you do not want the gate to open. If you are not using this at the top of the stairs and would like the
gate to swing in both directions, install both the upper and lower latches without the latch housings.
Step 8
Secure both the upper latch
and housing and the lower
latch and housing with the
mounting screws provided.
Step 9
Place the upper and lower spindles of the gate frame on
the upper and lower hinges. You may need to turn the
spindles so it fits on the hinge.
Step 10
Place the gate in the opening so that the distance
A (hinge side) is min. 1.3" (33mm) and max. 2.8"
(72mm). The distance B(Iatch side) is min.
1.2"(30mm)and max. 2.8" (72mm). Adjust the
protrusion of the hinge side and latch side
spindles by turning them so that the distance
between the gate frame and the opening meet
the required measurements.
The upper and lower latch spindles must be
engaged. Swing the gate closed to verify that the
latch spindles secure into the upper and lower
latches.
Step 11
Connect both the upper and lower top hinges with pins
to the lower hinges by lightly pressing downwards and
secure them into place. Secure with the hinge screws.
Note
raised
edge
A
Min 1.3
(3 3 mm)
Max 2.8
(7 2 mm)
Page 4
B
Min 1.2
(3 0 mm)
Max 2.8
(7 2 mm)
Publicidad
