Procedure For Use - Schulz SM1300 Manual De Instrucciones

8. PROCEDURE FOR USE

1. Caution and usea
• Unplug from the power outlet before performing any kind of adjustment, change of accessory or storing the
tool. These preventive safety measures reduce the risks of electrical shocks and of turning the tool on by
accident;
• Do not overload your tool, use it only for the adequate purpose. The correct power tool will do the job in
a better and safer way. Using the power tools for purposes that are different from what is indicated in the
manual might lead to hazardous situations;
• Perform maintenance on your SCHULZ power tool. Check if the moving parts are misaligned, bent or broken,
or if they bear any condition that might affect the correct operation of the machine. In case of fi nding an
abnormality that can't be solved, or if in doubt, have the tool serviced before using it again. Many accidents
are caused by lack of correct maintenance of power tools;
• Keep the cutting tools sharp and clean. The proper maintenance of the tool's cutting edges prevents them
from bending and improves handling.
• Keep hands away from the cutting blade and the cutting area, never put your hands under the workpiece,
because the cutting blade might cause serious injuries.
2. Specifi c Safety Instructions for Marble Cutter
ATTENTION
Always pay attention to the position of the cutting blade, which is exposed.
• Keep hands away from the cutting blade and the cutting area, never put your hands under the workpiece,
the disc spins under the workpiece and putting your hand near the cutting area will increase the risks of
accidents.
• Do not hold the material to be worked in your hands or put it on your leg, it's important that the material be
adequately clamped down, reducing the contact with the body and the possibility of losing control of the
equipment;
• Hold your tool by the handle when working. Do not operate the tool on surfaces under which there might be
electrical wires, and water or gas pipes. The contact with electrical wires or water might cause electrical
shocks. The electric motor generates sparks that, if in contact with fl ammable gases, might cause explosion;
• Always use blades of correct sizes and with round holes. Blades with shapes that don't match the backing
fl ange on which they'll be assembled will work in an irregular way, causing loss of control of the tool.
• Never use damaged or incorrect bolts or washers, the ones that come with your tool were specially manu-
factured for your grinder, so that they provide the best performance and guarantee the safe operation of the
equipment.
• Never plug or unplug the tool from the power outlet if either the plug or the power outlet is wet. First turn off
the circuit (circuit breaker or fuse) that energizes the tool. Then, remove the plug from the power outlet and
check the plug and the power outlet for presence of water.
• Wait for the blade to come to a complete stop, note that there is a period of inertial movement before the
tool stops, after it's turned off.
• Use only accessories that are designed and compatible with the speed informed on the tool and in this
manual.
• The use of this tool might create and/or spread dust that may cause serious and permanent respiratory, and
other, injuries. To reduce the exposure to these substances, work in well-ventilated places and always use
dust mask.
Properly place the tool on the workpiece before turning the equipment on.
27