Fh-869M Holder For Medium-Format Slides; Inserting Slides; Removing Slides - Nikon SUPER COOLSCAN 9000 ED Manual Del Usuario

FH-869M Holder for Medium-Format Slides

FH-869M Holder for Medium-Format Slides
The FH-869M is used with medium-format (120/220, 2¼ or Brownie) slides with mounts
1.0–3.2 mm thick. It is equipped with two apertures: a smaller aperture for 6 × 4.5 or 6 × 6
slides and a larger aperture for 6 × 7, 6 × 8, and 6 × 9 slides.
Do Not Mix Positive and Negative Film
Do not place mounted negatives in the holder with positive slides.

Inserting Slides

Insert the slides between the guides. The
slides should be oriented to match the ap-
ertures in the holder and the refl ective fi lm
base should be up (
slide contacts the base of the clips.
Inserting Slides
Insert slides between the guides. Forcing
the slides onto the guides could damage the
slides or clips and prevent the scanner from
focusing correctly. To minimize resistance,
try inserting slides at a slight angle.

Removing Slides

Slide the mounts out from under the clips
that hold them in place.
Do Not Use Force
Do not use force when removing slides. Fail-
ure to observe this precaution could damage
the clips. Do not lift the slides up until fully
removed from the clips.
Do Not Store Slides in the Holder
Leaving slides in the holder for extended periods could damage the clips holding the slides in place.
26). Stop when the
Direction of
insertion
Guides
Thumbnails
displayed in
order shown
53