Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Switch (Fig 9)
The lathe is fitted with a no-volt switch. In the
event of a power supply failure the wood lathe
needs to be manually re-started by pushing the "I"
button on the switch.
Speed control (Fig 10)
1. The lathe motor must be running before you can
use the speed control lever.
2. The speed control lever can be turned to one of
ten fixed speeds. To set the speed, pull back on the
lever handle [1] and rotate the handle to the next
fixed speed. Use the index plate [2] to choose right
lathe speed.
3. Turn the lever clockwise to increase the speed
and turn counterclockwise to decrease the speed.
4. You must move the speed control lever to the
lowest speed setting before turning the switch off
(Fig 11), otherwise the motor may not start or be
damaged.
Tailstock (Fig 12)
1. Move the tailstock [1] by loosening the lock lever
[2] and pushing the tailstock to the desired position
on the bed. Lock by tightening the lock lever [2].
2. The spindle can extend up to 57mm from the
tailstock housing. You can move the tailstock
spindle [3] by loosening the spindle lock lever [4]
and then turning the hand wheel [5]. Lock the
levers [4] and [2] before operating lathe.
3. The tailstock spindle is hollow and can be
accessed from the hand wheel end. Use the
push-out rod to remove the center cup or to drill
holes through the center of a workpiece.
７
EN
Publicidad
Tabla de contenido
