Compact Disc - Teac SR-L50 Manual Del Usuario

Discs which can be played on this unit:
• Conventional audio CDs bearing the CD-DA logo
on the label:
?
• Properly finalized CD-R discs
Note:
< Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs may not
be playable.
< CD-RW discs cannot be played on this unit.
< Copy-protected discs and other discs which do not
conform to the CD standard may not play back
correctly in this player.
If you use such discs in this unit, TEAC Corporation
and its subsidiaries cannot be responsible for any
consequences or guarantee the quality of
reproduction. If you experience problems with such
non-standard discs, you should contact the
producers of the disc.
< Always place the disc on the disc tray with the label
side uppermost. (Compact discs can be played or
recorded only on one side.)
< To remove a disc from its storage case, press down
on the center of the case and lift the disc out,
holding it carefully by the edges.
How to remove the disc
How to hold the disc
< Should the disc become dirty, wipe the surface
radially with a soft, dry cloth.
6

Compact Disc

< Never use such chemicals as record sprays,
antistatic sprays or fluid, benzine or thinner to clean
the discs. Such chemicals will do irreparable
damage to the disc's plastic surface.
< Discs should be returned to their cases after use to
avoid dust and scratches that could cause the laser
pickup to "skip."
< Do not expose discs to direct sunlight or high
humidity and temperature for extended periods.
Long exposure to high temperatures will warp the
disc.
< CD-R discs are more sensitive to the effects of heat
and ultraviolet rays than ordinary CDs. It is
important that they are not stored in a location
where direct sunlight will fall on them, and which is
away from sources of heat such as radiators or
heat-generating electrical devices.
< Printable CD-R discs aren't recommended, as the
label side might be sticky and damage the unit.
< Do not stick papers or protective sheets on the
discs and do not use any protective coating spray.
< Use a soft oil-based felt-tipped pen to write the
information on the label side. Never use a ball-point
or hard-tipped pen, as this may cause damage to
the recorded side.
< Never use a stabilizer. Using commercially available
CD stabilizers with this unit will damage the
mechanisms and cause them to malfunction.
< Do not use irregular shape CDs (octagonal, heart-
shape, etc.). CDs of this sort can damage the unit.
< If you are in any doubt as to the care and handling
of a CD-R disc, read the precautions supplied with
the disc, or contact the disc manufacturer directly.