Publicidad
Idiomas disponibles
Idiomas disponibles
1=
2.
Firmly grasp the yellow shipping strap and pull until both
ends are completely
removed from washer.
Check that two (2) shipping pins were removed with the
shipping strap.
2. Screw the Iocknut onto each foot to within 1" (2.5 cm) of the
foot base.
3.
1"
(2.5cm)
Screw the feet into the threaded holes at the front corner of
the washer until the nuts touch the washer. Twist the feet to
install.
NOTE: Do not tighten the nuts until the washer is level.
Lev® tI"®
ss@
Properly leveling your washer avoids excessive noise and
vibration.
Install the Front Leveling Feet
1. Prop up the front of the washer about 4" (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
A
4. Tilt the washer back and remove the wood block. Gently
lower the washer to the floor.
Steps in Final Location
1. Slide the washer to its final location.
2. Tilt the washer forward until the rear of the washer is at least
4" (10.2 cm) off the floor. You may hear the self-adjusting
rear
feet click into place. Lower the washer to the floor.
//
4Jr
,,
(10.2 cm)
A. Self-adjusting
feet
A
3. Check the levelness of the washer by placing a level on the
top edges of the washer, first side to side, then front to back.
4"
(10.2crn)
A. Threaded holes for feet
4=
If the washer is not level, move the washer out slightly, tip
back, prop up the front of the washer with the wood block
and adjust the feet up or down as necessary by twisting the
feet. Turn the feet clockwise to raise the washer or
counterclockwise
to lower the washer. Repeat steps
1 through 4 until washer is level.
6
Publicidad
