Operating Instructions; Important - Dexter power J1G-ZP28-255A-EU Instrucciones De Montaje

FR

8. OPERATING INSTRUCTIONS

ES
PT
Important：
Be sure the supply is the same as the voltage given on the rating plate. Remove the mains
IT
plug before carrying out any adjustment or servicing.
ASSEMBLY
EL
Warning: To prevent the accidental starting that could cause possible serous personal
injury, ALWAYS assemble all parts to you saw BEFORE connecting it to the power supply.
The saw should NEVER be connected to a power supply when you are assembling parts,
EN
making adjustments, installing.
TRANSPORTATION
Lift the mitre saw only when the saw arm is locked in the down position, the saw is
switched off and the plug is removed from the power point.
Only lift the saw by the operating handle (3) or outer castings. Do not lift the saw using
the guards.
BENCH MOUNTING
To ensure that the mitre saw is always stable and secure.The saw base has holes in each
corner to facilitate bench mounting.
1. Place the saw on a level, horizontal bench or work table using bolts (not supplied) and
fix the saw to the bench using 4 bolts.
2. If desired, you can mount the saw to a piece of 1/2" (13 mm) or thicker plywood which
can then be clamped to your work support or moved to other job sites and re-clamped.
CAUTION! Make sure that the mounting surface is not warped as an uneven surface can
cause binding and inaccurate sawing.
RELEASE KNOB
The release knob (2) is provided for holding the cutting head down while transporting
or storing the mitre saw. The saw must never be used with the release knob locking the
head down.
MITRE TABLE LOCKS
The mitre table locks (18) are used to lock the table at the desired mitre angle.
The mitre saw cuts from 0° to 45° both left and right. To adjust the mitre angle loosen the
mitre table locks(18)(19) and rotate the mitre table to the desired position.
The mitre table features positive click stops at 0°, 15°, 22.5°, 30° and 45° for quick setting of
common mitre angles.
159