Briteq BT-60LS Manual De Instrucciones página 9

ENGLISH
OPERATE THE UNIT BY CA8 OR RF8SET
When used in standalone or master/slave mode we strongly advise you to use the CA-8 "Wired easy
controller" or RF-8SET "Wireless easy controller".
 CA-8 wired remote: Connect the controller to the jack input of the first unit (master).
 RF-8SET wireless remote: the wireless remote has two parts:
 RF-8T: small RF-transmitter that can control up to 5 effects.
 RF-8R: small RF-receiver that should be connected to the DIN 5pin input of
the BT-60LS. See the installation manual of the receiver for more information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
 The LED is off: with the FUNCTION button you can select different
strobe modes, like "sound strobe".
 The LED is blinking: with the FUNCTION button you can select
different shows.
 The LED is on: (music mode is temporarily switched off)
 Press the FUNCTION button shortly: to change the colors
 Press the FUNCTION button longer: to change the gobos
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
BRITEQ 13/89
®
OPERATION MANUAL
BT-60LS
ENGLISH
SPECIFICATIONS
Mains Input: AC 100 - 240V, 50/60Hz
Max Power consumption: 135 Watt
Sound Control: Internal microphone
Pan/Tilt: 540° / 270°
Beam angle: 15°
Fixed Gobo size: D=31,4mm, image = 23mm (only metal)
Rotating Gobo size: D=26,8mm, image = 21mm (glass or metal)
DMX connections: 3pin XLR male / female
Leds: 1 White LED 60Watt
Size: See drawing
Weight: 10,5 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
BRITEQ 14/89
®
OPERATION MANUAL
BT-60LS