Craftsman R100 Series Manual De Instructiones página 28

3. Remove the belt from around the tractor's PTO pulley. See "Figure 15".
WARNING
Avoid pinching injuries. Never place your fingers on the idler spring or
between the belt and a pulley while removing the belt.
4. Remove the bow-tie cotter pin and flat washer from the deck lift assembly,
and retain for reinstallation later. See "Figure 16".
SERVICE AND MAINTENANCE
Figure 15
Figure 16
5. Remove the remaining bow-tie cotter pins securing the deck to the unit, as
shown in "Figure 17".
NOTE: The bow-tie clips should be re-installed from the top down.
6. Move the deck lift lever into the top notch on the right fender to raise the
deck lift arms up and out of the way.
7. Unplug the wiring pigtail from the deck safety switch.
8. Carefully remove the PTO cable from the rear of the cutting deck by
removing the bow-tie cotter pin which secures it. Remove the spring from
the deck idler bracket. See "Figure 18".
9. Gently slide the cutting deck (from the left side) out from underneath the
tractor.
Changing the Deck Belt
NOTE: It is possible to change the deck belt with the cutting deck still installed on
the tractor, however it is much easier to remove the deck first, change the deck belt,
then reinstall the cutting deck.
To change the cutting deck belt, proceed as follows:
28
Figure 17
Figure 18