Publicidad
➭
46
Preparations
Preparazione
Preparación
Fig. 1
Fig. 1
Grab. 1
Fig. 2
Fig. 2
Grab. 2
2. Preparations
2.1 Power supply
The flash unit should only be powered by 2 CR2 lithium
batteries. This type of battery can be stored for many years
with virtually no loss of power, thus making it ideal for
occasional use.
The batteries are exhausted if the recycling time at full
light output exceeds 60 seconds. Remove the batteries
from the mecablitz if it is not going to be used for an exten-
ded period.
2.2 Replacing the batteries
• Turn off the flashgun by its main switch
• Press the unlocking button
compartment cover to the right and fold open (fig. 2).
• Insert the batteries as indicated by the symbols in the
battery compartment.
The supplied lithium batteries are consumables and not
subject to our guarantee conditions.
After the batteries have been loaded, fold down the battery
compartment cover and push back to the left until it be-
comes audibly engaged.
When loading the batteries ensure that their +
and - poles are aligned with the symbols.
Transposed poles can destroy the flash unit!
Always exchange both batteries, replacing
them with identical batteries of the same capa-
city from the same manufacturer! Do not dispo-
se of spent batteries in the domestic waste bin.
Spent batteries should be handed in to an
appropriate collecting point.
2.3 Mounting/Removing the mecablitz
Various Sony cameras have an accessory shoe
that does not comply to DIN standards. If a
"34 CS-2 digital" is used in conjunction with
such a Sony camera we recommend to always
utilize the supplied camera bracket.
Mounting:
• Turn off the mecablitz by its main switch .
• Turn the clamping disk
the flash unit.
• Slide the mecablitz foot
bracket, the SLAVE stand or the camera's accessory
shoe.
.
(fig. 1), slide the battery
upward against the housing of
all the way into the flash
Publicidad
Capítulos
