Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Operation Fig. 3
To turn on: Press the adjustment wheel 1x. The LED will briefly light
up green.
To turn off: Press the adjustment wheel 2x. The LED will briefly light
up red.
Dimming: Various methods possible!
1.) Turn the adjustment wheel in a clockwise direction to increase
brightness.
Turn anti-clockwise to reduce brightness.
2.) Re-sending an ON signal:
The dimming cycle is started by pressing the adjustment wheel when
switched on. Briefly press the ON signal again when the desired
brightness is reached.
3.) Another method is to press and hold the adjustment wheel until the
desired brightness is achieved.
Please note that older and newer wireless-dimmer-receiver models
may differ slightly.
The dimmer cycle is continuous on older models.
On newer models the brightness is stopped at the brightest and dim-
mest points respectively.
A synchronous dimmer cycle with multiple dimmer receivers is not
guaranteed.
Changing batteries Fig. 4
The CR2032 3V battery will last for approx. 20,000 operations (lifetime of
around 3 years)
The LED will light up red every 4 seconds when the battery is running
out.
Lift open the mounting plate with a screwdriver.
The + symbol must remain visible when you put the battery in.
When closing the wireless-wall transmitter with the mounting plate,
ensure that the arrow of the mounting plate and the arrow on the back
of the wall transmitting are both pointing upward.
All 6 clips must properly click into place.
If done correctly you should hear a distinct click.
Operating instructions
ITDW-854
›
Publicidad
