Publicidad
Idiomas disponibles
Idiomas disponibles
How to use
Callus Remover is designed for smoothing coarse skin on the feet and heels ,Do
not use this device anywhere else on the body.
1.
Wash and clean the skin and dry fully. Note: Do not use on broken or
bleeding skin.
2.
Make sure the Rollers Grinding Head is placed into the unit. See section of
Changing the Rollers Grinding Head on how to remove and replace head.
3.
Remove the protective cover from the unit and it is ready to Use.
4.
Turn on the unit by pressing the safety switch Sock, in the center of the On/
Off switch, and at the same time push the switch up (fig. 6).
5.
Gently rotate (back and forth or side to side) (fig.7) the callous/corn/hard
skin area for 2-3 seconds. Dot not press hard, gently glide the unit over
desire area. The unit will stop if it is press too hard on the skin. Stop and
check if you have achieved the softness you desire. If not, go over the area
for 2-3 more seconds and check again. Continue to use this method until
the level of smoothness is obtained.
6.
Warning: stop using if skin becomes sore or Inflamed.
7.
Warning: Do not use on skin for more than 2-3 seconds at a time.
8.
Turn the unit off (fig 8).
9.
Rinse the skin or use a wet towel to get rid of the excess dead particles.
10. To clean Callus Remover, please see the Cleaning section.
11. Keep the protective cover on your unit when it is not in use.
6
7
8
Publicidad
