Final Assembly - Hella Rallye 3000 Compact Instrucciones De Montaje

18
GB
ENGLISH
Headlamps must not vibrate
or jut above the bonnet and
must be attached
symmetrically. Choose a
straight surface for the fitting
position and mark the
Insert the connection cable
(2-wire) through the rubber
seal and into the housing.
Strip the cable and connect
using two blade connectors.
Fully insulated blade
connectors for the H1 bulb.

Final assembly

Put the housing together.
Screw the bracket and
housing together and route
the cables carefully.
Fitting: Rallye 3003 Compact: Page 6
attachment points.
Pilot-drill with the 3 mm
bit and then drill through
using the 11 mm bit. Seal
the drilled metal parts with
corrosion protection agent.
Press the rubber seal in
tightly to ensure water-
tightness.
Insert the bulb and lock
in place. Push the blade
connectors on.
Screw the headlamps to the
vehicle (using a two-point
bracket if necessary).
Align the headlamps and
tighten all screws.
To guarantee an optimum
beam pattern, make sure
that the "TOP" marking
on the headlamp insert
is always facing the top. Note!
Do not touch the bulb
with your bare fingers!
Use a tissue or similar.