Alto POSEIDON 1200 Instrucciones De Manejo página 39

8 Troubleshooting
Fault
Pressure drop
Pressure fluctuations
The motor does not start when
the cleaner is switched on
Cause
> Air in the system
> High-pressure nozzle
blocked/worn
> Pressure control on the
spray pipe is not set
correctly.
> Pump draws in air (only
possible in suction mode)
> Lack of water
> Water inlet hose is too long
or its cross-section too small
> Lack of water caused by
blocked water filter
> Lack of water because max.
permissible suction height
has not been heeded
> The plug is not inserted
properly, i.e. there is no
current
> The mains fuse is switched
off
Remedy
• Vent the system by operating
the spray gun several times
at short intervals. If
necessary, operate the
cleaner for a short time
without the high-pressure
hose connected
• Clean/replace the high-
pressure nozzle
• Set the required working
pressure
• Check that the suction set is
air-tight
• Open the tap
• Use specified water inlet
hose
• Clean the water filter in the
water connection (never
work without water filter)
• See instructions
• Check the plug, lead and
switch and if necessary have
them replaced by a trained
electrician
• Switch on the mains fuse
39