Before Use; Fitting The Side Handle; Working With The Tool - Hilti DEG125-D Manual De Instrucciones

b) Ensure that the workplace is well ventilated. Ex-
posure to dust at a poorly ventilated workplace may
result in damage to the health.
5.7.5 Personal protective equipment
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

WARNING
Never use the power tool without the guard.

6.1 Fitting the side handle

WARNING
The side handle must be fitted for all types of work.
The side handle may be screwed onto the tool on the
right or left.

6.2 Working with the tool

Take care to ensure that the closed side of the guard is
always positioned toward the operator's body.
Adjust the position of the guard to suit the requirements
of the work being done.
6.2.1 Fitting the guard 6
NOTE
The guard is equipped with locating lugs that ensure only
guards of a type suitable for use with the power tool can
be fitted. The locating lugs of the guard fit into the guard
mount on the power tool.
1. Disconnect the supply cord plug from the power
outlet.
2. Fit the guard onto the drive spindle collar so that the
two triangular marks on the guard and on the power
tool in alignment.
3. Press the guard onto the drive spindle collar; press
the guard release button and then rotate the guard
until it engages and the guard release button jumps
back to its outset position.
tion, protective gloves and breathing protection while
the power tool is in use.
6.2.2 Adjusting the guard 7
1. Disconnect the supply cord plug from the power
outlet.
2. Press the guard release button and then rotate the
guard until it engages in the desired position.
6.2.3 Removing the guard
1. Disconnect the supply cord plug from the power
outlet.
2. Press the guard release button and then rotate the
guard until the triangular marks on the guard and
the power tool are in alignment.
3. Lift off the guard.
6.3 Fitting the cutting / grinding disc 8
DANGER
Check that the speed rating printed on the grinding
disc is equal to or higher than the rated speed of the
tool.
DANGER
Check the condition of the grinding disc before us-
ing it. Do not use discs that are broken, cracked or
damaged in any way.
1. Disconnect the supply cord plug from the power
outlet.
2. CAUTION The clamping flange is equipped with an
O-ring. The O-ring must be replaced if missing or
damaged.
Fit the clamping flange onto the drive spindle.
3. Fit the diamond disc, cutting disc or grinding disc.
4. Screw on the clamping nut and tighten it.
en
27