Detergent And Rinse Aid - Sears KENMORE ELITE UltraWash 665.1396 Serie Manual De Uso

DETERGENT AND RINSE AID
IMPORTANT:
Use only automatic dishwashing detergent. Hand
dishwashing detergent will produce excessive suds and
overflow out of the dishwasher.
Recommended Detergent Amount
Add recommended amount of detergent to each
compartment as shown and close the detergent lid.
Powders and Gels
Water Soil Pre-Wash Main Wash
Hardness Level Compartment Compartment
Soft Light None 1/2
(0-4 grains Normal None 1/2
per U.S.
gallon) Heavy Full 1/2
Medium Light None 1/2
(5-9 grains Normal 1/2 1/2
per U.S.
gallon) Heavy FulP Full _
Hard Light 1/2 FulP
(10-14 grains Normal FulP FulP
per U.S.
gallon) Heavy FulP Full _
_Full pre-wash compartment contains 7 tsp (35 mL), and full
main wash compartment contains 9 tsp (45 mL).
Premeasured Detergents
Many detergents now come in premeasured forms (gel
packs, tablets, or powder packs). These forms are suitable for
all hardness and soil levels. Always place premeasured
detergents in the main compartment and close the lid.
IMPORTANT:
Extremely hard water mineral deposits (15 grains per U.S.
gallon or more) can cause damage to your dishwasher and
make it difficult to achieve good results. A water softener is
recommended to avoid damage and achieve good results.
You may bring your water samples to Sears to check
hardness level.
USERINSE AIDFOR
BETTER DRYING
Lock
Refillc__
Full
Add
IMPORTANT:
Your dishwasher is designed to use a liquid rinse aid. The use
of rinse aids greatly improves drying by allowing water to
drain from the dishes after the final rinse. They also keep
water from forming droplets that can dry as spots or streaks.
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1. Turn the knob to the REFILL position and remove.
2. Pour rinse aid into the opening until the indicator points to
FULL. Do not overfill.
3. Clean up any spilled rinse aid. Spilled rinse aid can
create excessive suds.
4. Replace the knob and turn to the LOCI< position.
NOTE: Indicator reads correct fill level when door is
completely opened.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water
conditions, the factory setting of 2 will give good results. If
you have hard water and notice calcium buildup (water
spots) on your dishware, you may want to try a higher setting.
If you notice foam in your dishwasher, use a lower setting.
Lock
Refill
To adjust the setting
1. Turn the knob to the REFILL position and remove.
2. Turn the arrow inside the dispenser to the desired setting.
3. Replace the knob and turn to the LOCI< position.
10