Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
SOLUTION
HARD WATER
(WHITE RESIDUE ON
DISHWASHER
INTERIOR OR
GLASSWARE)
ODORS
NOISY
NOTE: Extremely
hard water
mineral deposits can cause damage
to your dishwasher
and
make it difficult
to achieve
good cleaning.
You may bring water samples to Sears to check
your water
hardness level. A water
softener is strongly
recommended
if your hardness is
15 grains or more. If a water softener is not installed,
the following
steps may help:
Use a commercial
cleaner
designed
for dishwashers
once per month.
Clean the ULTRA WASH ®HE filters at least once per month.
Always
use a rinse aid.
Always
use a high-quality,
fresh detergent.
Use a detergent
booster/water
softener additive
designed
for dishwashers.
NOTE: If the dishwasher
is not used daily, you can run a rinse cycle with the partial
load
daily until a full load is ready to run, or use the Top Rack Only option (on some models) for
partial
loads.
Run a vinegar
rinse through the dishwasher
by putting 2 cups (500 mL) of white vinegar
in
an upright
glass measuring
cup in the lower rack. Run a normal
cycle with the Heated Dry
option turned off. Do not use detergent.
The dishwasher
may not be draining
properly,
see "WATER REMAINS
IN THE TUB/WILL
NOT DRAIN" in "Troubleshooting."
NOTES:
•
Surging sounds can occur periodically
throughout
the cycle while the dishwasher
is
draining.
•
Normal
water valve hissing may be heard periodically.
•
A normal snap sound may be heard when the detergent
dispenser opens during the
cycle and when the door is opened at the end of the cycle.
•
Improper
installation
will affect
noise levels.
Be sure the filters are properly
installed.
A thumping
sound may be heard if items extend beyond the racks and interfere
with the
wash arms. Readjust the dishware
and resume the cycle.
FOOD SOILS REMAIN
ON DISHES
Be sure the dishwasher
is loaded
correctly.
Improper
loading
can greatly
decrease the
washing
performance
(see "Loading
for Best Performance").
Check filter to ensure it is properly
installed.
Clean it if needed. (See "Cleaning
Instructions"
in "ULTRA WASH ®HE Filtration
System" for details.)
Select the proper cycle and option for the type of soils. The Pots & Pans cycle with the
TURBOZONE
TM
(on some models) option can be used for tougher
loads.
Be sure the incoming
water
temperature
is at least 120°F (49°C).
Use the proper amount of fresh detergent.
More detergent
is needed for heavier-soiled
loads and hard water conditions.
Scrape food from dishes prior to loading
(do not prerinse).
DISHES DIRTY/SUDS
IN
DISHWASHER/CYCLE
NOT
COMPLETE
If foam or suds are detected
by the dishwasher
sensing system, the dishwasher
may not
operate
properly
or may not fill with water.
Suds can come from:
•
Using the incorrect
type of detergenh
such as dish detergent
for hand washing
dishes, laundry
detergent,
or hand soap.
•
Not replacing
the rinse aid dispenser cap after filling
(or refilling)
the rinse aid.
•
Using an excessive amount of dishwasher
detergent.
Call for service.
DID NOT SANITIZE
If the sanitized
light is blinking,
the load is NO T sanitized.
The cycle was interrupted
in the
final rinse, or the temperature
for your water
heater is set too low. Set your water heater to
120°F (49°C).
23
Publicidad
