Looking After And Servicing The Wrk; Accessories; Disposal; Warranty - Weller WRK Manual De Uso

8-8
1. Position the pick-up over the workpiece (see 6.1) and prepare
desoldering (see 6.2).
2 . Feed the hot-air tool from the side through the designated nozzle
opening up to the workpiece and actuate the tool until the
workpiece is detached and raised by the pick-up fitting.
The marker ring is now in the upper position.
3 . Remove the hot-air tool and switch off.
4 . Position the pick-up together with the nozzle and the workpiece
subjected to suction on the desired set-down surface.
5 . Carefully press the pick-up downwards and switch off the
vacuum.
The workpiece is set down on the set-down surface.
Note Y ou can also work with the HAP 200 without a reflow nozzle, e.g. in
th e case of workpieces > 30 mm.

7 Looking after and servicing the WRK

Clean the WRK on a regular basis with a mild special-steel cleaning
ag ent.
8

Accessories

005 15 15 499 WRK holder
005 87 617 30 Desoldering set 33x33/24x24 with pick-up
005 87 617 31 Desoldering set 27x27/20x20 with pick-up
005 87 617 32 Desoldering set 18/15.5/12.5/10 with pick-up

9 Disposal

Dispose of replaced equipment pa
accordance with the rules and regulations applicable in your co

10 Warranty

Claims by the buyer for physical defects are time-barred after a
period of one year from deliver
claims by the buyer for in
§§ 478, 479 BGB (Germa
We shall only be liable arising
quality or durability warranty has been furnished by use in w
and using the term "Warranty".
rts, filters or old devices in
y to the buyer. This does not apply to
demnification in accordance with
n Federal Law Gazette).
from a warranty furnished by us if the
WRK
untry.
riting