Listening To The Radio - Brandt BCR97P Manual De Instrucciones

SETTING THE CLOCK AND SNOOZE DURATION
1. Place the unit on a flat stable surface.
2. Connect one end of the power adapter into the DC 5.5V power socket on the rear of the unit. Plug the
power adapter into the mains socket.
 The display will show 0:00.
3. Press SET once.
 The hour digit will flash on the display.
4. While the hour digit is flashing, press or press & hold / until the desired hour appears. Press SET to
confirm.
 The minute digits will flash on the display.
5. While the minute digits are flashing, press or press & hold / until the desired minutes appear.
Press SET to confirm.
 The hour format will flash on the display.
6. While the hour format is flashing, repeatedly press / to select 12‐hour or 24‐hour format.
Press SET to confirm.
 The snooze time will flash on the display.
7. While the snooze time is flashing, press or press & hold / until the desired snooze time appears.
Press SET to confirm.
 The snooze time can be selected from 5 to 60 minutes.
NOTE: In 12 hour format "P" will appear on the display for PM time.
LISTENING TO THE RADIO
1. To turn on the radio press RADIO.
2. Tune in to the desired station by repeatedly pressing /.
 The wire aerial located on the rear of the unit is for FM reception. The wire should be fully
extended and positioned for optimum reception.
 Press and hold / for 2 seconds and then release the button, the unit will scan the frequencies
until a broadcasting station strong enough for good reception is found.
3. To adjust the volume, press VOL and the volume level will flash on the display. Repeatedly press
/ until the desired volume level is shown.
4. To turn off the radio, press
NOTE: Keep your radio away from fluorescent lamps or other electronic devices,
which may cause interference to the radio.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM radio stations can be preset.
1. Follow steps in "LISTENING TO THE RADIO" and tune in to the station that you wish to preset.
2. Press and hold SET until "ME" appears and "01" flashes on the display.
3. Repeatedly press / to select the desired memory slot.
4. Press SET again to store the station.
5. Repeat steps above to store desired stations.
To listen to preset radio stations, repeatedly press SET to select the desired radio station.
.
EN.4