Radio Operation - Brandt BCR150P Manual De Instrucciones

POWER ON/RADIO MODE
Press POWER to switch the unit on and enters the raido mode.
 The radio frequency will briefly appear on the display and then return to clock time.

RADIO OPERATION

1. Press POWER to turn on the radio.
 The default FM radio frequency is 87.5 MHz.
2. Adjust the volume by repeatedly pressing VOL-/AL1 or VOL+/AL2.
3. Repeatedly press TUNE/- or TUNE/+ to tune into the desired station.
 Press and hold TUNE/- or TUNE/+ for auto forward or backward radio station searching.
NOTE: For the best FM reception, extend the FM aerial to its full length.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 20 radio stations in FM could be preset.
Automatic Station Presetting
Press and hold TIME/MEM, this will auto scan all the available radio stations and preset the stations
from the current frequency and store them automatically from P01 to P20.
The scan will stop automatically when 20 stations have been stored or the full frequency scan has been
completed.
Manual Station Presetting
1. Follow steps in "RADIO OPERATION" and tune in to the station that you wish to preset.
2. Press TIME/MEM, "P01" will be shown on the display.
3. Repeatedly press TUNE/- or TUNE/+ to select the desired memory slot.
4. Press TIME/MEM again to store the station.
5. Repeat steps 1 to 3 to store desired stations.
To listen to preset radio stations, press PRESET repeatedly to select the desired radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
1. In standby mode, press and hold VOL-/AL1 or VOL+/AL2 for 2 seconds.
 "bU" will flash.
2. Press VOL-/AL1 or VOL+/AL2 while "bU" is flashing.
 The hour digits will flash.
3. Set the hours by repeatedly pressing TUNE/- or TUNE/+.
4. Press VOL-/AL1 or VOL+/AL2 to confirm.
 The minute digits will flash.
5. Set the minutes by repeatedly pressing TUNE/- or TUNE/+.
6. Press VOL-/AL1 or VOL+/AL2 to confirm.