NEFF D2615X0GB/02 Instrucciones De Uso Y Montaje página 66

Installation
The extractor hood can also be installed
slightly lower, depending on the height of
the wall cupboards. Position the template
correspondingly lower.
Observe the minimum distance from hob to
650 mm
extractor hood of
screws
must be fitted
above the hob
).
3. Predrill (with bradawl or 2 mm bit) and
screw in the screws to 5 mm.
4. Suspend the extractor hood on the two
screws between the wall cabinets.
5. The two door carriers of the extractor
flap must be pushed into the appliance
to he stops.
6. Align the extractor
hood with the lea-
ding edge of the
side cabinets.
66
fixing
(the
at least 1040 mm
5 mm
Important
: If the door of the unit is at a
distance from the body of the unit (e.g. due
to rubber stops), the extractor hood must
be drawn forward by the same distance.
7.
Mark the position of the lower fixing
screws, predrill and fasten the screws.
8.
All four fixing screws must be firmly tight-
ened.
9.
Connect pipes.
10.
Connect electricity.
Mounting the door:
Door thickness: min. 16 mm
Door height: 380 to 700 mm
Door weight: 7 kg (max.)
In order to match the wall cabinets on either
side, the door can project at the top and
bottom.
1. Remove the two door carriers to the
right and left, by pulling both the red pla-
stic catches inwards and removing the
door carrier out towards you.
2.
600
1.