Troubleshooting Guide - HAEGER FC-563.004A Instrucciones De Uso

English
Maintenance
1. The fan's natural movement can cause certain connections to loosen.
Check mounting connections, fastening parts, and blade accessories twice
a year. Check that they are well fastened.
1. Clean the fan periodically to help maintain its new appearance. Do not use
water to clean it, as this may damage the motor or the wood, or could
cause electrical shock.
2. Use only a soft brush or microfiber cloth as to not scratch the finish. The
veneer is sealed with a layer of lacquer to minimize discoloration or loss of
shine.
3. It is not necessary to oil the fan. The motor contains bearings with permanent
lubrication.
Important: Make sure there is no electrical power before starting to perform the
indicated maintenance.
Trouble shooting guide
The fan does not start
1. Check the fuses and circuit breakers.
2. Review the connections of the terminal block according to the indications
in the installation. Ensure the power is off before doing this.
3. Make sure that the sliding switch is firmly in the position of up or down. The
ventilator does not work when the button is in the middle.
4. Make sure that the stabilizing tongue-pieces of the motor are off.
5. Finally, if the fan will not start call an electrician do not attempt to touch the
internal parts.
The fan is noisy
1. Check that the screws in the motor casing are attached correctly.
2. Check that the screws fastening the blade brackets to the engine block are
properly tightened.
3. If using an optional light fitting, ensure the glass is properly fitted and / or the
screws holding the glass are firm.
4. If a solid-state speed control has been fitted this can cause noises in the
motor do not use these controls.
5. Allow at least 24 hours for the fan to settle, as many noises will go away. Each
blade set is weighed and is a complete set, if installing more than one fan
do not mix the blades as this can cause wobble.
8 Instructions for use