Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL
MOWER
HOUSING
Adjust the mower while tractor is parked on
level ground or driveway.
Make sure tires are
properly
inflated (See side of tire for proper
PSI).
If tires are over or underinflated,
you
will not properly
adjust your mower.
SIDE-TO-SIDE
ADJUSTMENT
.
Raise mower to its highest position.
. At the midpoint
of both sides of mower,
measure
height
from
bottom
edge
of
mower
to ground..
Distance
%" on both
sides
of mower
should
be the same or
within
1t4" of each other,.
• If adjustment
is necessary,
make adjust-
ment on one side of mower
only.
. To raise one side of mower, tighten lift link
adjustment
nut on that side..
• To lower one side of mower, loosen lift link
adjustment
nut on that side_
NOTE:
Each fullturnofadjustmentnutwill
change
mower
height about !18".
. Recheck
measurements
after adjusting.
FRONT-TO-BACK
ADJUSTMENT
Bottom edge
Bottom edge of
of mower to ___.
_
@Qw, er to ground
0 o,n0
AT L2L
"7,T-A
_L_
Suspension Arm
......
o__
A
/
Lift Link
Adjustment Nut ------'- .....
IMPORTANT:
Deck must be level side-to
side. Ifthe following front-to-back
adjustment
is necessary,
be sure to adjust
both front
links equally
so mower will stay level side-
to-sideo
To obtain the best cutting results, the mower
housing should be adjusted so thatthe
front is
approximately
t18" to 112" lower than the rear
when the mower
is in its highest
position,.
Check
adjustment
on right side of tractor.
Measure
distance
"D" directly
in front and
behind the mandrel
at bottom edge of mower
housing
as shown.
• Before
making
any
necessary
adjust-
ments, check that both front links are equal
in length.
• If links are not equal in length, adjust one
link to same length as other linko
• To lower
front of mower
loosen
nut "E"
on both front
links an equal
number
of
turns_
• When
distance
"D" is II8" to 1/2" lower
at front than rear, tighten nuts "F" against
trunnion
on both front links.
22
• To raise front of mower, loosen nut"F" from
trunnion
on both front links, Tighten
nut
"E" on both front links an equal
number
of turns.. The two front links must remain
equal in length.
. When
distance
"D" is 118" to 1/2" lower
at front than rear, tighten
nut "F" against
trunnion
on both front links.
,
Recheck
side-to-side
adjustment
°_\',
l
oo!
_"{_
\
__-
Mandrel
Both Fronl
nks Should be
ual in Length
)
/
Fron
Nut "E"
kinks
......
"
Publicidad
