Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TOPCOM TWINTALKER 1400
•
Replacing or modifying the antenna may affect the PMR radio specifications and violate the CE regulations.
Unauthorised antennas could also damage the radio.
3.6
NOTES
•
Do not touch the antenna while transmitting, it could affect the range.
•
Remove the battery if the device is not going to be used for a long period.
4
CLEANING AND MAINTENANCE
•
To clean the unit, wipe with a soft cloth dampened with water. Don't use a cleaner or solvents on the unit; they can
damage the case and leak inside, causing permanent damage.
•
Battery contacts may be wiped with a dry lint-free cloth.
•
If the unit gets wet, turn it off and remove the batteries immediately. Dry the battery compartment with a soft cloth
to minimize potential water damage. Leave the cover off the battery compartment overnight or until completely
dry. Do not use the unit until completely dry.
5
DISPOSAL OF THE DEVICE
Dispose of the unit and used batteries in an environment friendly manner.
Do not dispose of batteries in a normal household garbage.
6
USING A PMR DEVICE
To communicate between PMR devices they need to be set all on the same channel and within receiving range (up to
max. 3 km in open field). Since these devices use free frequency bands (channels), all devices in operation share these
channels(total 8 channels). Therefore, privacy is not garanteed. Anybody with a PMR set to your channel can overhear
the conversation.
If you want to communicate (transmitting a voice signal) you need to press the
button pressed, the device will go into transmit mode and you can speak into the microphone. All other PMR devices
in range , on the same channel and in standby mode (not transmitting) will hear your message. You need to wait until
the other party stops transmitting before you can reply to the message. At the end of each transmission the unit will
send a beep. To reply, just press the
If 2 or more users press the
only the stongest signal and the other signal (s) will be supressed. Therefore you
should only transmit a signal (press
7
GETTING STARTED
a
b
c
4
- button and speak into the microphone.
PTT
- button at the same time the reciever will receive
PTT
7.1
REMOVING/INSTALLING THE BELT CLIP
1.
To remove the clip from the unit, push the belt clip (b) towards the antenna,
while pulling the clip tab (a).
2.
When re-installing the belt clip, a click indicates the BeltClip is locked into
position.
7.2
BATTERY INSTALLATION
1.
Remove the belt clip (§ 7.1).
2.
Press the battery cover and slide it away from the antenna. (c)
3.
Install three 'AAA' alkaline or rechargeable batteries following the polarity as
shown.
4.
Re-install the Battery Cover (c) and Belt Clip (§ 7.1).
PTT
- button) when the channel is free .
PTT
- button (Push to talk). Once this
TOPCOM TWINTALKER 1400
Publicidad
Tabla de contenido
