Refrigerator Use; Ensuring Proper Air Circulation; Prepare The Water System; Using The Controls - IKEA P9WB2L Manual De Instrucciones Para El Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Plug into a grounded 3 prong outlet.
2. Flush the water system. See the "Prepare the Water System"
or "Water and Ice Dispensers" sections.
NOTE: Allow 24 hours to produce the first batch of ice. Allow
72 hours to completely fill ice container.

Prepare the Water System

Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly cleaned.
1. Open the freezer door and turn off the ice maker. See the "Ice
Maker and Storage Bin" section.
NOTE: If your model has a water filter, make sure the filter is
properly installed. See the "Water Filtration System" section.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
2. Flush the water system. Use a sturdy container to depress
and hold the water dispenser lever for 5 seconds, and then
release it for 5 seconds. Repeat until water begins to flow.
Once water begins to flow, continue depressing and releasing
the dispenser lever (5 seconds on, 5 seconds off) until a total
of 3 gal.
(11.4 L) has been dispensed. This will flush air from the filter
and water dispensing system and prepare the water filter for
use. Additional flushing may be required in some households.
As air is cleared from the system, water may spurt out of the
dispenser.
3. Open the freezer door and turn on the ice maker. See the
"Ice Maker and Storage Bin" section.
Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced.
10

REFRIGERATOR USE

Ensuring Proper Air Circulation

In order to ensure proper temperatures, you need to permit air
to flow between the two sections. Cold air enters the bottom of
the freezer section and moves up. It then enters the refrigerator
section through the top vent. Air then returns to the freezer as
shown.
Do not block any airflow vents. If the vents are blocked, airflow
will be obstructed and temperature and moisture problems may
occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.

Using the Controls

The refrigerator and freezer controls are located on the dispenser
panel.
IMPORTANT: The display screen on the dispenser control panel
will turn off automatically and enter Sleep mode when the control
buttons and dispenser pad have not been used for 2 minutes or
more. While in Sleep mode, the first press of a control button will
only reactivate the display screen, without changing any settings.
Touch any control button on the dispenser panel to activate
the display screen. The home screen will appear as shown.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

P9rfwb2l

Tabla de contenido