Replace the water tank cap, aligning the
threads on the tank with the threads on the
cap, and turn it clockwise. (See Fig. 3)
Turn the tank over, holding one hand by the
top handle and another hand under the
water tank. Place the full water tank on the
base, making sure it fits securely. Place the
medicine cup on top of the mist channel.
Plug the power supply cord into a wall socket
and turn on the unit. The On/Off dial is located on the base.
The power light will turn blue.
Use the On/Off dial to adjust the intensity of the mist output by selecting
either (1) for lower mist output or (2) for higher mist output.
When the humidifier runs out of water the blue power light will turn off and
the mist output will stop. This safety feature sues a water level sensor to turn
off the heating element once the water level sinks below the required level in
the water basin. A small orange light will appear to indicate that the
humidifier has automatically turned off. Turn the humidifier off and unplug
before removing and refilling the water tank.
IMPORTANT: Overheat red light
When the humidifier runs out of water, the BLUE light will turn off and mist will
stop. If the unit has overheated, a small RED light will turn on (light will appear
near the "2" on Control Knob). The RED light indicates that the unit has
overheated. Turn the humidifier off, unplug the unit, allow the basin and water to
cool, then empty water in basin. Turn the humidifier basin over and press the
Reset Button, with a pen or pencil tip, on the bottom of the Water Basin. This will
reset the humidifier.
How to use the medicine cup
The medicine cup allows the addition of
medications recommended for use with warm
mist humidifiers only.
Remove the medicine cup from the top of the
mist chamber for easier filling.
BE CAREFUL not to overfill the medicine cup.
Overfilling may cause medicine to spill into mist
8
User instructions
Fig. 3