weasy SX9 Manual De Usuario página 3

When disassembling or assembling the juicer, press the
2.
upper of feed port of the cover with your hand, then force
the handle to slide in or out of cover slot.
When disassembling juicing net, first remove the cover and
3.
waste container, then turn the middle ring up to 30 degrees
by holding juicing nozzle with your hand, and take up, the
juicing net will automatically leave the rotor.
In order to avoid damage, before using, first check power
4.
supply for compliance with rated voltage.
Clean all parts able to disassemble (refer to the section of
5.
"maintenance and cleaning").
When assembling, please carefully read the diagram of "the
6.
names and the positions of the main components".
Please carefully read the "warning" before using.
7.
*Juicing
Before using, please confirm the button switch of the main machine in stop state, in this way, in
1.
case the assembly is not completed, starting the main machine can be avoided, so unnecessary
damage for persons or property avoided.
Before juicing, first confirm juicing net and rotor clutched in position, and no hard contact between
2.
juicing net cutter and transparent cover. Put the transparent cover on, put the handle into the cover
slot, and then turn on the device.
For using, assemble according to the diagram of "the names and the positions of the main
3.
components". Turn on power supply, press switch to let the machine run no-load for 5sec. Put
prepared vegetables or fruits into feed port of the juicer, press with the pushing bar, evenly, hard
and slowly, juice of vegetables or fruits will pour, original, fresh, good for health.
Note: when pressing food with the pushing bar, force shall be even or indirect, pressing force shall
4.
not be more than 1 kg, no too sudden force, otherwise, juicing effect will be reduced.
*Operating time:
This machine is designed with button switches of O grading, I grading, II grading (O for stop, I for
weak grading, II for strong grading). For juicing, select strong grading, for operating time, after
operating for 1min, stop for 1min, then use again. After the previous operation is done for three
times, stop for 15min, do not operate until the motor is cooled, in this way, service life of this