Functional Overview; Charge Status Indicator; Technical Data - Normfest SL 550 Instrucciones De Uso

NORMFEST SL 550
GB Operating Instructions
Many thanks for choosing a product from NORMFEST.
With the following instructions we would like to
help you to get the best from the functions of your
new light.

FUNCTIONAL OVERVIEW

• Professional workshop lamp with COB LED
technology
• Auxiliary light at the head of the lamp
• Robust, splash-proof plastic housing with rubber-
coated grip
• Can be swivelled through 120°, lamp grip can
be locked in 5 positions for flexible direction of
the light
• Mounting magnet on the underside of the grip
• Main light with two light functions (50% | 100%
light power)
• Permanently installed Li-ion rechargeable battery
pack (3.7V | 2600mA)
• Can be charged via micro-USB port
• Charge monitoring via 3 green LEDs
• Remaining capacity indication via 3 green LEDs
• Switch on the grip
• Charge socket on lower grip

TECHNICAL DATA

Main light: 5W COB LED
Auxiliary light: 3W SMD LED
Lighting intensity: 785 Lux (0.5m distance)
Luminous flux: 550 lumen 100% |
260 lumen 50%
Battery life: Main light 100% 2.5h |
50% 5.5h
Auxiliary light 10h
FIRST USE
The on/off switch for the workshop light can be found
on the rear of the housing:
Press 1x: The auxiliary light on the head of the lamp
will be switched on.
Press 2x: The auxiliary light on the head of the lamp
will be switched off.
At the same time, the main light will be switched on
at the 50% setting.
Press 3x: The main light illuminates at the 100%
setting.
Press 4x: Both lights are off.
CHARGING
Charge the workshop lamp fully before using for the
first time.
If the workshop lamp has been stored for an exten-
ded period of time it should likewise be fully charged
again before first use.
The following charging options are available:
• Via USB mains adapter plugged into the mains
outlet
• Via USB car adapter connected to the cigarette
lighter of the vehicle
• Via USB cable connected to a third party device
with a USB output port (e.g. PC, laptop)
To charge the workshop light, pull the sealing cap
off the micro-USB socket on the rear of the lamp.
Connect the USB cable with one of the charge
options listed above and the lamp. Then plug the USB
mains adapter / USB vehicle adapter into a socket /
cigarette lighter.

CHARGE STATUS INDICATOR

The workshop lamp has a professional LED status
display on the rear of the lamp. This can be used
to display the current charge status as well as the
remaining capacity of the integrated battery pack.
Display of the charge status of the battery
pack during the charge procedure:
• Three LEDs illuminate green: Rechargeable batte-
ry is fully charged.
• Three LEDs flash green: Charge status between
60 and 99%
• Two LEDs flash green: Charge status between 30
and 59%
• One LED flashes green: Charge status between 0
and 29%
Display of the remaining capacity during
operation:
• Three LEDs illuminate green: Remaining charge
between 100 and 67%
• Two LEDs illuminate green: Remaining charge
between 66 and 34%
• One LED illuminates green: Remaining charge
between 33 and 10%
• One LED flashes green: Remaining charge below
10%
The workshop lamp is protected against over-char-
ging. This means that you can leave the workshop