Publicidad
If the supply cord of this appliance is damaged, it must only be replaced by a repair
shop appointed by the manufacturer, because special purpose tools are required.
Warning: Do not connect the blue or brown wire to the earth terminal of the plug!
The wires in this mains lead are coloured in accordance with the following code:
blue = neutral
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifiying the terminals in your plug, proceed as follows:
Should the moulded plug have to be replaced, never re-use the defective plug or
attempt to plug it into a different 13 A socket. This could result in an electric shock.
Should it be necessary to exchange the fuse in the plug only use fuses approved by
ASTA in accordance with BS 1362. 13 Amp fuses may be used.
To ensure that the fuse and fuse carrier are correctly mounted please observe the
provided markings or colour coding in the plug.
After changing the fuse, always make sure that the fuse carrier is correctly inserted.
With out the fuse carrier, it is not permissible to use the plug.
The correct fuses and fuse carriers are available from your local electrical supplies
stockist.
54
Mains plug replacement (GB only)
Warning
brown = live
GB
Breaks in work
• Turn off device.
• Place spray gun in spray gun holder.
Closing down and cleaning
1. Turn off device. Open trigger so that the
coating material in spray gun runs back
into the container.
2. Unscrew the container. Return remaining
coating material into the material can.
3. Clean the container and ascending pipe
with a brush.
4. Fill the container with solvent or water.
Screw container back in place.
Only use solvent with a flash point of
over
21° C.
Turn on device and spray the solvent or
water into a container.
If a tube is not used, some solvent or water
will be deposited outside the container.
This is due to the high air volume.
5. Repeat the above procedure until clear
solvent or water comes out of the nozzle.
6. Turn off device.
7. Then completely empty the container.
Always keep the container seal free of
coating material and check for damage.
8. Clean the outside of the spray gun and
container with a cloth soaked in solvent or
water.
Publicidad
Capítulos
