TRUCK PAC ES-1224 Manual Del Operador página 8

Question: Can the TRUCK PAC
recycled?
E
Answer: Yes, the environment was
N
one of our main concerns in
G
the development and
L
designing of the TRUCK
I
S PAC
H
can dispose of this product at
its life's end.
Question: What is the ideal in-use
storage temperature of the
TRUCK PAC
Answer: Room temperature. The
TRUCK PAC
operate at below zero
temperatures, however its
power will be less. Intense
heat will accelerate self
discharge.
Question: I have a regular 10 amp
battery charger, can I use it to
recharge the TRUCK PAC
Answer: No, only the wall charger
supplied with the TRUCK
PAC
higher amp charger may
damage the batteries.
Question: Is the TRUCK PAC
proof?
Answer: No. Jump starting instructions
must be followed. See back
of TRUCK PAC
Question: I'm recharging my TRUCK
PAC
light immediately come on?
Answer: No. The charged light will
only come on once the
Booster pac approaches full
charge. However, the
charging light (first one on the
left) should come on
indicating that charging is
taking place.
8
TM
TM
. Most battery outlets
TM
?
TM will also
TM should be used. A
TM
goof
TM
.
TM , should the charged
be !!! IMPORTANT !!!
BATTERY REMOVAL AND
DISPOSAL
Pb
The batteries inside this TRUCK PAC
are sealed lead-acid batteries. By LAW, it
is required to be removed and recycled or
disposed of properly. While there are
federal regulations that must be followed
throughout the United States, your
individual state or local governments may
have additional regulations to be followed
in your area.
When the batteries in this product are in
need of replacement, remove it according
to the instructions provided below and
TM
?
take it to your local recycling center for
proper recycling or disposal. If you don't
have a local recycling center that handles
sealed lead-acid batteries, contact your
local environmental agency for
instructions.
Battery Removal Instructions
Begin by making sure that both booster
clamps are securely stowed in their
holsters on each side of the TRUCK
TM
PAC .
1. Remove all 13 screws (4 on the left
side, 4 on the right side, 4 on the
bottom, and 1 under the front label
near the top). Then lift off the back
cover.
2. Remove the cables from the
batteries.
3. Lift the battery out of the front half of
the enclosure.
4. To install a new battery, reverse the
above procedure.
NOTE: Remember that the red wires
Contains sealed,
non-spillable lead
acid battery. Must
be disposed of properly.
connect to the positive (+)
battery terminal and the black
wires connect to the negative
(–) battery terminal.
TM