En
Emptying the dust canister
Fig. 11
If the suction power diminishes, the dust canister must be emptied and the filters must be
cleaned. We recommend to empty the dust canister outside of the house.
a) Remove the suction hose from the dust canister. Press the dust canister release button and
remove the canister by bringing it forward.
b) To empty the dust canister, simply push the bottom release button so that the bottom of
the canister opens and the dust falls out. Hold the dust canister over a rubbish container
whilst you are emptying it.
c) Loosen the filter lid and remove the entire filter insert from the dust canister. Empty the
remaining dust from the dust canister.
d) Re-assemble all of the components that have previously been removed. Assembly is
carried out in reverse order.
Cleaning the main filter
a) Loosen the filter lid and remove the entire filter insert from the dust canister. Break down
Fig. 12
the filter into all of its individual parts. Tap the filter to remove the dust and clean all other
parts with water and dry them thoroughly.
b) Re-assemble all of the components that have previously been removed. Assembly is
carried out in reverse order.
Cleaning the exhaust air filter
Fig. 13
Remove the wheel cap and take out the filter. Gently pat the filter until dust falls off / use
brush to clean the filter. Assembly is carried out in reverse order. Insert the filter in the right
direction so that the correct side is facing the motor.
TROUBLESHOOTING
If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not work
Product cannot absorb dust or
loose suction power
SPECIFICATION
Rated voltage
Rated power input
Protection class
• This is a general purpose vacuum cleaner
• The Erp test method is according to (EU) No 666/2013 +Amd. (EU) 2016/2282; (EU) No 665/2013
+Amd. (EU) 2017/254; EN 60312-1:2017; EN 60704-1:2010/A11:2012 & EN 60704-2-1:2015
• Please refer to below website for detail technical information, or contact the manufacturer for
technical document: www.ok-online.com
DISPOSAL
Do not dispose of this product as municipal waste. Return it to a designated collection point for
the recycling of electrical and electronic equipment. Contact your retailer or local authorities for
more information.
IM_OVC3115A-180103_V06_HR.indb 10
Possible causes
• Interrupted power supply
• Filters are blocked with dirt
• Dust container full
• Suction hose/ telescopic tube
blocked with dirt
: 220 - 240 V~ 50/60 Hz
: 800 W
: II
10
Solution
• Check the power supply
• Clean and wash the filters
• Empty dust container
• Clean and wash the suction
hose/telescopic tube
3/1/18 6:37 pm