Delta 50-767 T2 Manual De Instrucciones página 10

ATTACHING MOTOR BLOWER
ASSEMBLY TO STAND
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP
1. Place motor blower assembly onto stand.
2. Align the brackets on the blower housing,
on the motor end, to the rear blower
housing supports.
3. Rear blower housing supports fit inside
the brackets on the blower housing, as
shown. (Fig 6)
4. Align holes on front support assembly to
blower housing assembly (Fig 7).
5. Insert M8 hex socket head screw through
hole and thread into blower housing (Fig 8).
6. Tigten screw.
7. Repeat on other side .
ASSEMBLY (continued)
10
FIGURE 6
FIGURE 7
FIGURE 8