Bixpy Jet Manual De Usuario Y Guía De Seguridad página 5

MATING AND MAINTAINING YOUR BIXPY CONNECTORS
Your Bixpy Jet Thruster and Power Packs, Adapters and Accessories are equipped with connectors
that are rated to withstand water depths of 30m (or 100 feet). As such, the first few times you
connect your device, the connectors are more difficult to mate until they are "broken-in". DO NOT
use force, pliers or other tools to mate your connectors. Be patient and use a towel for better grip if
necessary. Over-tightening the connectors will NOT provide a better water seal and broken
connectors are not covered under your warranty.
In general, it is a good idea to fill your connectors with dielectric grease before mating, especially if
you use your equipment in or near salt water. If you are taking your device below 10m (30 feet), you
MUST fill ALL connectors with dielectric grease - this includes your charging connectors.
The connector caps on your thruster housing and adapter wires are there to protect your
connectors during storage and transportation. Remove and store them when using the jets in
water. The connector cap on your charging and auxiliary ports must be installed tightly at all times
when near water. Never cap and store a wet connector!
1
i.
2
ii.
3
Align connector pins (1) with your thruster's connector notches (2).
Hint: when new, your connector pins are marked on the outside for
easier identification.
4
• Push your adapter connector (3) into the thruster's connector (4)
• Rotate your connector nut 175° until you feel the nut
"lock" into place. Hint: watch this instructional video:
www.bixpy.com/connect
WARNING:
YOUR BIXPY CONNECTORS ARE ONLY WATERPROOF WHEN
MATED PROPERLY and ONLY SPLASH PROOF WHEN
EXPOSED!!!
E
4