Publicidad
Idiomas disponibles
Idiomas disponibles
1. POWER IN: Connect the supplied mains lead to this connector and to an appropriate wall outlet.
2. DMX IN: Connect a DMX cable from the DMX output connector of a DMX controller to this DMX
input
3. Built-in microphone with adjustable sensitivity
4. LED display for the menu settings
5. DMX OUT: Connect this output to the DMX input connector of a slave unit
6. POWER OUT: Connect this power output to the POWER IN connector of a slave unit
7. Safety hook: For additional fastening of the unit to a truss system to avoid accidental falling of
the unit.
CONTROL PANEL
The control panel is the mechanism for configuring the settings. It has a small LCD screen and four
buttons, which are described below.
8.8.8.8.
MENU
UP
DOWN
ENTER
BUTTON FUNCTION
<MENU>
Scrolls through the first level of options, or exits from the current menu or function
<UP>
Navigates upward through the menu list or increases the numeric value when in a function
<DOWN>
Navigates downward through the menu list or decreases the numeric value when in a function
<ENTER>
Enables the currently displayed menu or sets the currently selected value in to the current function
CHANGING THE FILTER
The unit is supplied with 2 filters: one clear filter and one Frost filter allowing to vary the effects.
The frost filter spreads the light at a wider angle e.g. to illuminate a wall.
To change the filter, proceed as follows:
Remove the 4 screws
EN
4
Remove the filter
Put the new filter in place
Fasten the 4 screws
© Copyright LOTRONIC 2019
Publicidad
