Description Of The Device - Stylies GALAXY Instrucciones De Uso

DESCRIPTION OF THE DEVICE

The device consists of the following main components:
Mist cap guide
1.
Transparent water tank
2.
Display
3.
Control panel
4.
– On/Off switch
– Automatic shutdown timer
– Mist quantity (1-3)
– Air humidity (45-75 %) rel. + «CO»
=Continuous
– Light dimmer
10. Water tank grip
11. Water tank
12. Base of the humidifier
13. Power cable
14. Tank lid
15. Descaler cartridge
16. Bottom carrying handle
17. Descaler cartridge opening
18. Water tank
STARTING UP / QUICK GUIDE
This quick guide helps practised users to start the device in a few steps. For detailed start-up
instructions, please consult the next chapter.
Place the humidifier on a stable and watertight surface, never
1.
on a carpet or parquet floor.
Hold the water tank firmly by the handle (10) and pull it up-
2.
ward.
Turn the tank upside down. Unscrew and remove the tank lid
3.
(14).
Fill the tank with 5.5 litres (1.45 US gallons) of cold water.
4.
14
Timer display
5.
Low water warning
6.
Automatic mode display
7.
«45 %RH» air humidity
8.
«1-3» mist quantity levels
9.
19. Ultrasonic membrane, do not touch;
danger of burning
20. Silver Cube
21. Hygrostat sensor
22. Water collector
23. Mist chamber (removable)
24. Water level sensor
25. Outlet basket (removable)
The descaler cartridge (15) is works-fitted. Please check that it
5.
is firmly screwed on (5.) (6.).
To change the descaler cartridge (15), unpack a new one and
firmly screw it onto the tank lid (14).
The «Silver Cube» (20) is works-fitted (more details on page 17).
6.
Screw the tank cover with cartridge firmly onto the tank.
7.
Turn the tank upside down and check for water leakage.
8.
Install the tank, and you should hear a bubbling sound (water
9.
collector filling).
10. Insert the power plug (you should hear and see a power-on
signal).
11. As soon as the water collector is completely full, the red sym-
bol in the middle of the display goes out. The humidifier is now
ready to use.
12. Press the left hand key
mist dispersion.
13. Set the desired humidity (45-75 % rel.) by repeatedly pressing
the key .We recommend 40 - 60 %. The humidity setting is au-
tomatically monitored («Auto» light). Set «CO» for continuous op-
eration without humidity monitoring, but this may cause excess
1./8.
humidity if used too often.
14. Set the desired misting quantity (3 stages) by repeatedly press-
ing the middle key
15. Press the key
maximum brightness.
16. Press the timer key
shutdown time in hours. «0:00» switches the timer off again.
3.
to switch on the humidifier and start
Turn the mist nozzle on top into the room.
to dim the LED light. Press again to switch it to
repeatedly to activate the automatic
5.
«Silver Cube» 6.
7.
10.–13.
15