Powering On And Off - Zagg slim book go Manual De Instrucciones

INSERTING/REMOVING YOUR DEVICE
1. Hold your device in landscape mode with the volume control
buttons facing up. Insert the top half of your device at an angle
into the top of the case and apply light pressure to snap it snuggly
into place.
2. Press the bottom half of your device into the cover and press it in.
Press all around your device to ensure it has seated properly.
3. Once your device has been inserted into the case, set the case into
the cradle hinge on the keyboard. You should feel the magnets
connect as the case clicks into place.
4. To easily remove your device from the case, first detach the case
from the keyboard. (See directions below.) Then hold the top of
the case with one hand and press against the back of the case with
the other. Then grasp the exposed side of your device and lift/pull
it away from the cover.
DETACHING THE CASE FROM THE KEYBOARD
1. To detach the case and the keyboard, open the case at a 90˚ angle to
the keyboard.
2. Hold one of the top corners of the keyboard with one hand, and
with the other hand on the corresponding top corner of the case,
pull directly up. This will disengage the magnets holding the
keyboard and case together.

POWERING ON AND OFF

1. To turn your Slim Book Go on, press the Power button located at
the top right corner of the keyboard. A green LED will light briefly.
2. To turn your Slim Book Go off, press and hold the Power button for
three seconds. A red LED will flash indicating it has turned off.