Changing Needle; To Remove And Attach The Foot Holder; To Remove; To Attach - Sears Kenmore 385.16765 Manual De Instrucciones

Changing Needle

1 Needle clamp screw
2 Needle clamp
1 Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw
turning it counterclockwise. Remove the needle from the
needle clamp .
2
2 Insert a new needle into the needle clamp
flat side to the rear. When inserting the needle into the
needle clamp , push it up as far as it goes. Tighten
2
the needle clamp screw
3 To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.

To Remove and Attach the Foot Holder

1 Thumbscrew
Foot holder
2
3 Presser bar

• To remove

Remove the thumbscrew
with a screwdriver.

• To attach

Match the hole in the foot holder
hole in the presser bar
the hole. Tighten the screw
a screwdriver.

Changing Presser Foot

1 Snap-on button (red button)
2 Groove
3 Pin
• To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button
1
• To attach
Place the selected presser foot, so that the pin
foot lies just under the groove
the presser bar to lock the foot into place.
with the
2
firmly by turning it clockwise.
1
by turning it counterclockwise
1
with the threaded
2
. Fit the thumbscrew
3
by turning it clockwise with
1
on the back of the foot holder.
on the foot holder. Lower
3
1
by
1
into
1
1
on the
2
10
Flat side
Lado plano
Méplat vers
1
2
2
3
1
1
Needle
Aguja
Aiguille
2
3
3
2