Before Use; Handling Of The Packed Machine; Unpacking Of The Machine; Squeegee Assembly - Floorpul ruby 45e Manual De Uso Y Mantenimiento

GB

BEFORE USE

HANDLING OF THE PACKED MACHINE

The machine is supplied with suitable packing fore-
seen for fork lift truck handling.
The total weight is 111 kg.
Packing dimensions:
Base: 118 cm x 67 cm
Height: 119 cm
ATTENTION:
Do not place more than two packings on top of each
other.

UNPACKING OF THE MACHINE

1. Remove the external packing.
2. Unscrew the brackets (1+2) that secure the ma-
chine to the pallet.
3. Move the machine backwards, as indicated in the
figure, avoiding heavy contacts to mechanical parts.
4. Keep the pallet for eventual transport.

SQUEEGEE ASSEMBLY

With the squeegee support lowered, slide the two
stud bolts (1) placed on the upper part of the squee-
gee, inside the slots on the support. Block the squee-
gee by rotating the lever (2) clockwise.
Insert the squeegee hose (3) into its coupling, re-
specting its position as indicated in the figure.

ADJUSTMENT OF THE SQUEEGEE HEIGHT

The squeegee must be adjusted in height depending
on the rubber wear. In order to guarantee a perfect
drying during the operation, the lower blade of the
rear squeegee rubber (4) must work slightly bent
backwards (operator side) in uniformed way in all its
length.
Acting clockwise upon the two registers (5) it is pos-
sible to increase the bending of the rubber. Acting
counterclockwise it is possible to decrease the rubber
bending.
A label placed near the two registers (5) indicates ro-
tation sense to increase or reduce the height.
Note: The wheels of the squeegee support must be
adjusted through the registers (5) at the same height
so that the squeegee works parallel to the floor.

ADJUSTMENT OF THE SQUEEGEE INCLINATION

In case of need, to increase the rubber bending in
the central part, it is necessary to tilt the squeegee
body rotating counterclockwise the register (6). To
increase the rubber bending on the squeegee ex-
tremities, rotate the register clockwise.

SPLASH GUARD ASSEMBLY

The two splash guards have to be assembled onto the
brushes base group. Insert the metal strips inside the
suitable slots present on the rubber. Place the round
hole at the flat extremity of the strip onto the screw
placed in the front part of the brushes base group.
Secure the strips through the nut blocking it.
Hook the spring in the rear part of the brushes base
group to the slot placed at the extremity of the
metal strip still free. Please act as above for both the
splash guard rubbers, paying attention to reduce to
the minimum the gap between the two rubbers in
the front part of the brushes base group.
17
With brushes assembled, the splash guard must
slightly touch the floor.

MANUAL ASSEMBLY OF THE BRUSHES

ATTENTION:
Check that the mains plug is disconnected.
1. Acting upon the pedal (12) lift the brushes base
group.
2. With the brushes base group in lifted position,
insert the brushes into their plate seat underneath
the brushes base turning them until the three metal
buttons are properly seated in their slots; rotate en-
ergically the brushes to push the button towards the
coupling spring until they get blocked.
The figure shows the rotating sense for brushes cou-
pling.
We suggest to invert daily the brushes position, in
order to guarantee a longer operating life of them.
Whenever brushes were deformed we suggest to re-
assemble them in the same position, avoiding that
the different inclination of the bristles causes exces-
sive motor overload or troublesome vibrations.
GB