Dometic PerfectRoof PR4500 Instrucciones De Uso página 41

Ocultar thumbs Ver también para PerfectRoof PR4500:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 77
PR4500
If the LED does not light up, remove the batteries and reinsert them cor-
rectly (fig. 6 C, page 3).
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of
them at collection points.
6.7
Closing the awning manually in emergencies
If the awning is damaged, the motor is faulty or the power supply is unavail-
able, the awning can be closed manually.
To do this, you need the following tools:
z Screwdriver
z 10-mm open-ended or ring spanner.
!
WARNING!
Disconnect the awning from the power before you start the proce-
dure. Otherwise the awning could start working again unexpect-
edly. The awning motor could rotate the hexagonal shaft causing
the tool to spin uncontrollably and lead to serious injury or cause
serious damage to your vehicle.
➤ Undo the screw (fig. 7 2, page 4) with a screwdriver and remove the
cover cap (fig. 7 1, page 4).
➤ Turn the hexagonal shaft (fig. 8 1, page 4) anti-clockwise with a 10 mm
open-ended or ring spanner, until the awning is fully retracted.
I
NOTE
z Due to its design, the awning is not able to retract as far man-
ually, as it can in the electric mode. A gap remains between the
front cover and the housing. This does not affect safety.
z When the awning has been retracted manually, the settings
are no longer correct. After repair, the awning needs to be
reset, see chapter "Resetting the motor and remote control" on
page 45.
➤ Put on the left-hand cap.
➤ Contact the service partner in the respective country to get the awning
repaired.
EN
Operating the awning
41

Publicidad

Tabla de contenido
loading

Tabla de contenido