König Electronic CMP-BLUEHS20 Manual De Uso página 3

2. Pairing the headset with Bluetooth devices
2.1. How to enter the pairing mode
Function
Enter into pairing
mode
Note:
* The pairing mode will last 2 minutes. If the headset still cannot pair with any Bluetooth devices, it will
automatically switch into standby mode.
2.2. Pairing the headset with a Bluetooth mobile phone
Please make sure your mobile phone has a Bluetooth function.
Specific pairing procedures may vary with different mobile phones. Please refer to your mobile phones'
manual for further information. The steps are as follows:
a. Please keep the headset and mobile phone within 1 metre of each other when pairing
b. Make the headset enter the pairing mode (please refer to 2.1)
c. Switch on the Bluetooth function of the mobile phone and search for Bluetooth devices. When the search
is completed, select the headset in the Bluetooth device list.
d. When prompted, enter PIN No: "0000" as the password and press "Yes" or "Confirm".
e. After pairing the devices successfully, select the headset in the Bluetooth device list and press "Connect".
f. If the connection is successful, the blue (or red) LED of the headset blinks twice every 4 seconds.
Note:
* If the pairing is not successful, please switch off headset first then try to pair them again according to the
steps mentioned above.
* After pairing, the devices will remember each other.
* The headset will connect with the last paired device. If you want to pair it with other Bluetooth devices,
please switch off the Bluetooth function of the current Bluetooth device, then pair and connect the new
Bluetooth device according to steps mentioned above.
3. Pairing the headset with a Bluetooth transmitter
You can enjoy music wirelessly by connecting the headset with a stereo Bluetooth transmitter. See the
manual of your transmitter for more details.
4. Making a call with the headset
Function
Voice dial
Redial last number
Volume up
Volume down
Answer call
Reject call
End call
Switch conversation
between headset and
mobile phone
Operation
First, make sure the headset
is off. Press O for 5-7 seconds
and release until the red and
blue LEDs blink alternately
Status of the headset
Standby mode
Standby mode
Conversation mode
Conversation mode
Ringing
Ringing
Conversation mode
Conversation mode
LED indicator
The red and blue LEDs blink
alternately
Operation
Press O for 2 seconds
and release until a tone is
heard
Briefly press O twice
Briefly press + and then
release (or hold) it
Briefly press – and then
release (or hold) it
Briefy press O
Press O for 2 seconds
and release until a tone is
heard
Briefly press O
Press O for 2 seconds
and release until a tone is
heard
3
Indication tone
Two tones
Indicator tone
A long tone
A long tone
None
None
A short tone
A short tone
A short tone
A short tone